Rail Swivel Mount Diamond Base

The RAM Rail Mount consists of a locking tooth system with a standard RAM diamond plate end. The mount will fit a rail diameter from 1.0" to 1.1". To mount to a circular rail, simple slide the plastic "U" clamp along the rail and then connect and tighten the small nut and bolt to close the U clamp. Next connect the diamond plate to the mounted clamp at the required angle and screw in the other bolt through the diamond plate. Now you are ready to connect any of the RAM composite or any other holder with two holes positioned 1.912" center to center. Placing a rubber lining (not included) between the tube and the mount for a tube with a diameter less than 1" will help the base grab the rail.

Material:
High Strength Composite

Common Applications:
Bicycle Mount

Note:
You cannot rotate the diamond plate on the U clamp when the holder is connected. 
Also please do not attempt to press the clamp over the rail as it will break. It must be slid on from one end.